CALIBRE SERVER INSTALL
CALIBRE SERVER UPGRADE
CALIBRE SERVER SOFTWARE

If you are running the server from the main calibre program, use Option and using -manage-users to create the user accounts.

User authentication for calibre-server by using the -enable-auth User accounts on the server and use the -username and -password If you want to enable access over the internet, then you should setup Preferences → Sharing over the net → Advanced. The server from the main calibre program, this option is in The local computer to make changes to your calibre data. You can simply use the -enable-local-write option of theĬontent server, to allow any program, including calibredb, running on There, it is not tested/supported.If you plan to connect only to a server running on the same computer, While calibre might work with versions of dependencies other than those listed The up-to-date list of dependencies that the official calibre binaries are bundled with,

CALIBRE SERVER INSTALL

Run the following commands in a terminal:Ĭd calibre* & sudo python3 setup.py install Dependencies.

Install the various dependencies listed below.

Make sure your system has Python 3 installed.

If you're still determined to install from source, read on: Please do not open bug reports or expect any form of support. If you install from source, you are on your own.

CALIBRE SERVER SOFTWARE

Sudo mkdir -p /opt/calibre & sudo rm -rf /opt/calibre/* & sudo tar xvf /path/to/downloaded/calibre-tarball.txz -C /opt/calibre & sudo /opt/calibre/calibre_postinstall Source install WARNING: calibre is a highly complex piece of software with lots of very finicky dependencies. Assuming you want calibre in /opt/calibre, run the following command, changing the path to calibre-tarball.txz below as appropriate:

CALIBRE SERVER UPGRADE

If you wish to revert to an earlier calibre release or download a calibre upgrade manually, download the tarball of that release from here (choose the 32-bit or 64-bit version, as appropriate). Sudo -v & sudo calibre-uninstall & wget -nv -O- | sudo sh /dev/stdin version=4.23.0Ĭhange 4.23.0 above to whatever version you want installed. You can install a previous calibre release, like this: Wget -nv -O- | sh /dev/stdin install_dir=~/calibre-bin isolated=y You can also do an 'isolated' install that only touches files inside the installation folder and does not need to be run as root, like this:.Sudo -v & wget -nv -O- | sudo sh /dev/stdin install_dir=/optĬhange /opt above to whatever folder you want calibre automatically installed to. You can change the folder calibre is installed into from the default (/opt) like this: On servers, if you get an error about a missing libEGL, you might need to install some OpenGL packages such as libegl1 and libopengl0.If you get an error Could not load the Qt platform plugin xcb you are missing some needed X11-XCB libraries, such as libxcb-xinerama0, for details see here.You need GLIBC 2.31 or higher and libstdc++.so.6.0.28 (from gcc 9.3.0) or higher to run calibre.Alternately, simply deleting the installation folder will remove 99% of the installed files. You can uninstall calibre by running sudo calibre-uninstall. You must have xdg-utils, wget, xz-utils and python ≥ 3.3 installed on your system before running the installer. Sudo -v & wget -no-check-certificate -nv -O- | sudo sh /dev/stdin If you still want to proceed, pass the -no-check-certificate option to wget, like this:

If you get an error about an untrusted certificate, that means your computer does not have any root certificates installed and so cannot download the installer securely.

Calibre server